Heath Zenith Motion Sensing Security Light User Manual
Motion sensor light control for canadian tire, Operation, Model sl-5411
- Heath Zenith 240-degree Motion-sensing Security Light
- Heath Zenith Motion Sensing Light
- Heath Zenith Motion Sensor Light
- Heath Zenith Motion Light Troubleshooting
- Heath Zenith Security Light Instructions
Heath Zenith 240-degree Motion-sensing Security Light
Mode:
Jul 02, 2018 Heath Zenith HZ-4144-BK 150 Degree Motion Sensing Decoractive Security Light with DualBrite Technology, Black -Amazon.com. View and Download Heath Zenith Motion Sensor Light Control SL-5412 owner's manual online. Motion Sensor Light Control. Motion Sensor Light Control SL-5412 Outdoor Light pdf manual download. Also for: Sl-5412-wh-a - heath - motion-sensing twin security light, Sl-5412-bz-b - heath.
On-Time:
Works:
View and Download Hikvision DS-2CD2112 quick operation manual online. Network Dome Camera. DS-2CD2112 Security Camera pdf manual download. Also for: Ds. HIKVISION DS-2CD2012-I User Manual 95 pages Related Manuals for HIKVISION DS-2CD2012-I Security Camera HIKVISION DS-2CD883F-EW Installation Manual. Hikvision ds-2cd2112-i manual.
Day
Night
Test
5 Sec
x
x
Auto
1, 5, 10 min.
x
Manual
Until Dawn*
x
OPERATION
© 2004 DESA Specialty Products™
595-5766-03
* resets to Auto Mode at dawn.
MANUAL MODE
ON-TIME
10 5 1 TEST
10 5 1 TEST
ON-TIME
TEST
.. back on.
AUTO
1 Second OFF
then..
Put the ON-TIME switch in the 1, 5, or
10 minute position.
Put the ON-TIME switch on the bottom
of the sensor in the TEST position.
Manual mode only works at night
because daylight returns the sensor
to AUTO.
Flip the light switch off for one second
then back on to toggle between AUTO
and MANUAL MODE.
Manual mode works only with the ON-
TIME switch in the 1, 5, or 10 position.
Move ON-TIME Switch to
1, 5, or 10 minutes
Mode Switching Summary
Heath Zenith Motion Sensing Light
Flip light switch off
for one second then
back on*
MANUAL MODE
AUTO
TEST
Requirements
• The Light Control requires 120-volts AC.
• If you want to use Manual Mode, the control must be
wired through a switch.
• Some codes require installation by a
qualified electrician.
• This product is intended for use with the enclosed
gasket and with a junction box marked for use in wet
locations.
Model SL-5411
Light Control
Sensor
Cover
Plate
Lamp
Holders
Features
• Turns on lighting when motion is detected.
• Automatically turns lighting off.
• Photocell keeps the lighting off during daylight hours.
• LED indicates motion was sensed (day or night).
Motion Sensor Light
Control for Canadian
Tire
* If you get confused while switching modes, turn the
power off for one minute, then back on. After the
calibration time the control will be in the AUTO mode.
Arduino nano 3.0 user manual. (For use with a normally open switch).EStop – These pins can be connected to an emergency stop switch. This does the same as the RESET button on the Arduino board. This makes it easier to install two limit switches for each axis.
Note: When first turned on wait about 1
1
/
2
minutes for
the circuitry to calibrate.
Plastic Hanger
Rubber Plug
Gasket
Mounting Strap
Mounting Bolt
2 Wire
Connectors
This package includes:
6 Screws
Heath Zenith Motion Sensor Light
(3 sizes included)